Rule Change Proposal Deadline - Thursday 11/9

Questions, comments, and discussions concerning COMSCC rules.

Moderator: blindsidefive0

Post Reply
Speed Racer
Speed Racer
Posts: 361
Joined: Mon Oct 26, 2009 7:01 pm

Rule Change Proposal Deadline - Thursday 11/9

Post by dtlemoine » Mon Nov 06, 2017 5:44 pm

Rule change season is in full swing - the newly formed Rules Committee has been busy reviewing your proposals in preparation for submission to the Board of Directors for further discussion and voting.

Due to a technical challenge on our back-end, some rule change proposals did not make it to our Chief Steward. If you submitted a rule change proposal and have not received any sort of confirmation, please assume your proposal was not received, and resubmit it by emailing Derek directly at Please include the following information:
  • Name
  • Rule Book Section
  • Current Rule Text
  • Proposed Rule Text
  • Supporting Information
Proposals are due this week - by end of day Thursday 11/9 - to allow the Rules Committee sufficient time to review and wordsmith before sending to the Board of Directors.

Our next BOD meeting is next Wednesday, Nov 15th, at Salvatore's Restaurant in Andover - the meeting starts at 7pm. The BOD will spend a few minutes reviewing the submissions during the meeting, followed by formal discussion and debate offline. If you're advocating for a particular rule change, please be sure to send as much supporting info as you can gather - this helps the Rules Committee and BOD throughout the process.

Important note: while the Rules Committee is actively reviewing discussions in these forums, they are not necessarily considering each open-ended forum thread as a formal submission. If you see a discussion that you feel strongly about, I encourage you to submit it as a formal proposal. Don't worry about creating duplicates, the Committee will sort through and consolidate where appropriate.

Looking forward to seeing folks next week at the BOD meeting!


E36 328is | SD #14

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest